clone stamp doesn't work on reopened project file
Posted: 25.03.2019 23:22
Hello,
After reopening a project file wanting to retouch the stack I made, I can't use anymore the clone stamp in a proper way.
It is still copying but as if it was shifted or offset? (sorry I don't speak english as well as I wish I could) so it doesn't match the good area as it used to when I used it before saving the file project. Something went wrong during the reopening I guess or recording. Anyway I tried with another stack as a test, saved it, reopened it and I got the same issue, I can't clone properly anymore and keep working on my retouching work unless on reopened project files.
Any help or trick to fix it?
I'm using the last version of Helicon and made a stack with Raw files turned into dng via Adobe Dng Converter.
Thanks for your answer.
After reopening a project file wanting to retouch the stack I made, I can't use anymore the clone stamp in a proper way.
It is still copying but as if it was shifted or offset? (sorry I don't speak english as well as I wish I could) so it doesn't match the good area as it used to when I used it before saving the file project. Something went wrong during the reopening I guess or recording. Anyway I tried with another stack as a test, saved it, reopened it and I got the same issue, I can't clone properly anymore and keep working on my retouching work unless on reopened project files.
Any help or trick to fix it?
I'm using the last version of Helicon and made a stack with Raw files turned into dng via Adobe Dng Converter.
Thanks for your answer.