Problem: i can select point A and point B and save them without problem, i can play with apertures, iso and shutter speed and everything seem to be perfect, but, when i actually start shooting point a goes wayy closest to what i saved and point b tooo, so my first pictures are all blurry adn the last pictures leave the back of my composition blurry, all the resr (the middle section) is perfect, i spend about 3 hours yesterday and couldnt solve this myself. I add a funny diagram to show you the setup and the actual shooting
B
|---------------------B (Furthest point becomes blurry)
|---------------------|
|---------------------|
|---------------------|
A-------------------|
----------------------A (closest points focus nothing)
Point a and b move when i start shooting
Point a and b move when i start shooting
Last edited by proxohms on 04.10.2018 04:21, edited 1 time in total.
- Stas Yatsenko
- Posts: 3841
- Joined: 06.05.2009 14:05
- Contact:
Re: Point a and b move when i start shooting
Are you shooting with interval set to "Auto"? Did you calibrate your DOF calculator as described here? https://www.heliconsoft.com/HeliconRemoteHelp/english/HeliconRemote.html#HR_CORECTION_FACTOR
What you've described could be because your interval is abnormally large, and that could be due to calculator not being calibrated.
What you've described could be because your interval is abnormally large, and that could be due to calculator not being calibrated.