Trinamic TMCM 1141

General discussions, bugs, support, suggestions
Post Reply
Posts: 2
Joined: 31.08.2014 10:47

Trinamic TMCM 1141

Post by Stralph » 12.05.2018 09:38

After successfully running a Trimatic PD2-110-232, I bought a second stepper from Trinamic. It is a PD42-3-1141 using a TMCM 1141 controller. I thought that I read that it should work when connecting to USB.
Unfortunately, Helicon Remote does not recognize the controller. Is there anything to do to make the application to recognize the TMCM controller?
I use Windows and my used Version is 3.8.7W. The stepper works nicely when using Trinamic's TMCL tool.

Thank you and best regards,

User avatar
Stas Yatsenko
Posts: 3850
Joined: 06.05.2009 14:05

Re: Trinamic TMCM 1141

Post by Stas Yatsenko » 15.05.2018 11:38

It should work. Make sure to close any other software capable of communicating with this stepper, then unplug it and plug it back in, then run Helicon Remote. Look for Trinamic under "Select a camera". If it's there, click to connect.
If Trinamic is still not detected, please send a bug report (Helicon Remote menu -> Feedback -> Report a bug).

Post Reply