Arduino and Helicon Remote

General discussions, bugs, support, suggestions
StefanS
Posts: 1
Joined: 15.09.2017 16:03

Arduino and Helicon Remote

Unread postby StefanS » 15.09.2017 16:25

Hello,

my community and me are using Helicon Focus for micro mineral photography. Our stacks are often more than 100 images. I will use helicon remote together with an arduino board to control my z stage. Is there a way to bring helicon remote together with an arduino board which also can be controled by serial commands.

The goal should be to set a start point, an andpoint and the numer of steps and the rest should do helicon remote. Make a picture drive some steps, wait a few seconds ... and the same again.

I already saw you did the same with trinamic stepper motors. This motors are very expensiv and difficult to get. For my arduino board, stepper motor and drive all to gether i spend less then 10€.

Kind regards Stefan

User avatar
Stas Yatsenko
Posts: 3955
Joined: 06.05.2009 14:05
Contact:

Re: Arduino and Helicon Remote

Unread postby Stas Yatsenko » 18.09.2017 11:30

You could download the serial protocol documentation for Trinamic and implement it in your Arduino board.


Return to “Helicon Remote”

Who is online

Users browsing this forum: Stas Yatsenko and 5 guests